what should max edge distince be in terramodel

Would it be more or less then how many mics you need to collect the total frequencies from 0 to gammaīased on audio signals i would have guest the other way around How many would typically be need to get 0 to gamma ray frequencies the majorityĪre we talking 2 ,3,4,5,6 different mic'sĪnd you won't have movement at that high frequencyĪlso how many mic /speakers can be used to actually send frequencies from 0 to gamma ray the majority? If you need to cover that much frequency, you would most likelly use a multi-mic setup So how about a mic or speaker to get the most out of the ELF to gamma ray frequency analogy for sound wavesīut making a 20-200 and 200-20k is way easier and cheaper To reduce the distortion due to the low frequencyĪs making a flat 20-20k speaker is very hard and expensive

Obviously the bigger speakers the more it takes to drive them so less sensitive in some senses The reason is due to the high movement of the low frequency They cann't produce sound wave like a mic takes in Good mic will cover easilly 20-20k within like 1db, but will cover way more than that, specially on the higher end Mics for converting mechanical to electrical obviously based on sensitivityīut only for a small band of frequencies of sound 'voice sound' Or do they typically uses tons of different speaker/mics to cover the complete sound wave bandwidth of frequencies out thereĪnd depending on the construction, it can have a wide or narrow bandwidthĪnd filters can flatten the responce even more Some mic or speaker that can detect and put out frequencies from close to 0 hz to frequencies in the gamma sound frequencies where gamma is the analogy of EM wave gamma frequency spectrumĪ mic will always be better than a speaker like say from low frequency to gamma frequency analog for sound wave/mechanical waves

What I am wondering is what currently is the mic or speaker with the greatest frequency response of sound. taking into account frequency response,sensitivity, and amplification the are really on in the same used for to different/opposite purposes one for collecting sound waves the other for creating sound waves. Is it much harder to work with? or give near unassisted forces?Īlso in theory a mic and a speaker are like a refrigierator and a heat pump the backwards version of one another. How do they do it so you still have manual control if the servo stuff mess up? (like pump failure) On small airplane with some hydrolic assistance.

What should max edge distince be in terramodel